Generally, dust will be deposited on the surface of the filter element after the use of the cartridge dust remover. At this time, it is necessary to clean the cartridge of the cartridge dust remover. As the manufacturer of the cartridge dust remover, the second ring environmental protection Co., Ltd. will discuss with you how to prolong the service life of the filter cartridge.

When designing the cartridge filter, some manufacturers usually design it as vertical insertion or horizontal insertion. When the degree of dust accumulation needs to be cleaned, generally, the vertical installation is better to clean. It is very likely that there will be ash deposition in the horizontal plug-in type. When the dust of the cartridge dust remover needs to be cleaned, the filter element is directly injected with the pulse valve to make the dust fall.
1. The filter cartridge is blocked. When the filter cartridge is blocked, the resistance increases, which can be indicated by the increase of the differential pressure gauge reading. The blockage of the filter cartridge is the main reason for the wear, perforation and falling off of the filter cartridge.
The causes of filter cartridge blockage are as follows:
(1) Strengthen the cleaning temporarily to eliminate the blockage of the filter cartridge;
(2) Partial or replacement of filter cartridge;
(3) Adjust installation and operating conditions.
Vertical filter cartridge dust collector
2. The filter cartridge is damaged. The shape of the filter cartridge and the installation method and mechanism of the filter cartridge determine the position where the filter cartridge is easy to crack, and can be inspected and repaired accordingly.
3. The filter cartridge is aged. Mainly due to the following reasons, cause investigation, elimination measures and filter cartridge replacement were carried out.
(1) Hardening and shrinkage caused by abnormal high temperature.
(2) Reactions are carried out by contact with vapors of acids, bases or organic solvents.
4. The old and new filters should not be mixed to avoid damage to the equipment and normal operation.
5. Change the filter cartridge, blow with compressed air first, and then check whether there are holes. If the hole is repaired, it should be replaced. If there is dust in the filter element, please rinse it with water and replace it.
If you want to know the relevant information of the cartridge filter, do it in the second ring. After decades of technical precipitation and continuous innovation, Jiangsu Erhuan Environmental Protection Technology Co., Ltd. has an elite team of R & D, design and production. The company has successfully developed slant insert filter cartridge dust collector and vertical ultra-high efficiency filter cartridge dust remover by introducing the fine production process of European and American dust collectors.