03 · COMMON SIZES & CUSTOMIZATIONCommon cartridge sizes & custom options
Find a common dimensional configuration below, then select the media and treatments described in Section 02. For replacement cartridges, confirm the complete mounting interface and seal against your existing element or drawing.
Standard-diameter & tapered cartridges
All dimensions are in millimetres. Open/open means both ends have air openings; open/closed means one air opening and a closed bottom with the listed fixing hole. A dash indicates no small bottom fixing hole. For tapered cartridges, the nominal diameter refers to the larger end; rectangular flange dimensions are length × width.
Listed media options follow the common configurations shown. Nanofiber coatings, PTFE membranes, flame-retardant treatments and antistatic options are specified separately; availability is confirmed with the quotation. Matching nominal size alone does not establish replacement compatibility.
Filtration Area & Pleat Design
Cartridges with the same external dimensions can be manufactured with different filtration areas by adjusting the pleat count and depth. For example, Ø352 × 660 mm cellulose cartridges can be supplied with 18, 20, 21 or 23.4 m² of media, while polyester cartridges of the same nominal size typically have approximately 9–10 m². The area can be customized to suit the media and application, subject to design confirmation.
With the same external dimensions and pleat depth, increasing the pleat count adds filtration area but reduces the spacing between pleats. If the spacing is too narrow, dust can accumulate between the pleats, making pulse cleaning and dust release less effective. Filtration area and pleat spacing should therefore be selected together for the dust characteristics and cleaning conditions; a larger area is not always the better choice.
Small-diameter pleated polyester cartridges
Common pleated bag-replacement configurations with plastic or metal end caps. Tube-sheet hole diameter is listed separately from end-cap diameter. Areas below are reference values for the listed designs and can be customized by adjusting the pleat design.
Plastic end caps
Metal end caps
All listed filtration areas are reference values and can be customized to suit the media and pleat design. Final filtration area is confirmed with the quotation.
Need another size or mounting interface?
Custom lengths, end caps, flanges, seals and support structures can be reviewed against a dimensioned drawing or sample. These tables show common configurations and do not cover every cartridge we can manufacture.
For a quotation: Send the cartridge dimensions, clear photos of both ends, the existing part number or equipment model where available, media requirements and quantity. Include dust type, operating temperature and moisture conditions for media selection.
Request a cartridge quotation →